Liquid jet mixers
Liquid jet mixers are jet pumps similar to the water jet pumps used to mix and circulate liquids. The jet mixer has lateral slots, where the surrounding medium is sucked in. Due to the high turbulence in the diffuser the result is an intimate mixing of the motive and suction fluid. The liquid mixture emerging from the jet mixer spreads out in conical form and entrains more liquid from its surroundings.
Simple and reliable
Corrosion and erosion resistant
Easy to install
Very low wear because there are no movable parts
Wide range of materials such as steal, stainless steal, cast iron, bronze, Teflon and graphite
Mixing and circulating of fluids in storage tanks, vessels or basins
Range of Operation
The viscosity of the circulation fluid must not be too high. Otherwise a sufficient mixing effect can not be guaranteed. As a rule, jet mixers can be used in all cases where the liquid to be mixed can still be supplied by a centrifugal pump.
The driving medium has to be free of bigger particles, to avoid the clogging of the driving nozzle.
Several mixers in a vessel yield a better mixture and homogeneity. The approximate number of mixers necessary may be found from the following rule of thumb:
High tanks: 100 - 400 m³/per mixer
Low profile tanks and basins: 30 - 100 m³/per mixer
The mixers should be more than 1.5 m below the liquid level in case of tendency to foam.
To obtain good operation even with low liquid level, jet mixers should be installed at the deepest possible point.
For establishing the number of mixers required, the following criteria is taken into account:
Geometry and size of vessel or tank
Type of liquid to be mixed
Maximum and minimum liquid levels